|
Specification:
black color
2 RJ45 connectors ( PoE and Lan port )
2.1*5.5mm & 2.5*5.5mm female DC plug
ROHS approval
Ethernet Date Rate: 10/100/1000Mbps
Case of Material: ABS 94V-0/PC
Features:
To achieve best performance of a Wireless LAN, the location of Access Point(AP) must be
carefully chosen. In most cases, finding a power supply for AP is a common obstacle.
Power over Ethernet(PoE) technology provides the ideal power solution to help overcome
these obstacles. In Ethernet, four pairs of C5 or C5E twisted pairs are used as the
medium for transmission. The actual data transmission, however, o-nly takes up two pairs
of wires(pairs 1-2 and 3-6). PoE technology utilizes the remaining pairs(pairs 4-5 and 7-8)
to conduct electricity.
MARKETS
• Remote routers, access points, and bridges
• Remote networking equipment
• Remote camera systems
• 400 MHz to 10 GHz systems
• SOHO equipment
• IP phone systems
• WiMAX
How PoE works
A device needs power to operate. Not volts or amps – power expressed as watts.
That power can be supplied at different voltages. The electronics inside the device needs usually about 3.3 or 5 volts. But at low voltages, the wires from power supply have a lot of loss beyond about 5 feet. So for short distance power, most IP phones and Cameras are shipped with a 12v or 24v power supply because 12v supplies are cheap. But these same devices, when powered via the Ethernet cable, use 48 volts. This is the 802.3af standard voltage. 802.3at using 56v – because the loss is even lower.
|